[HDD]

Tekkis siis kysimus ,et milleks see auk prose core peal hea on ...
Võtmehoida panemise auk vee ??

[pealuu]

hmm... kui kindel sa oled et see auk on core peal? ma pakuks küll et tegemist on heat spreader'iga.. ja core on selel all varjus.

[HDD]

pealuu, ära nori nüüd .. tean ise ka ,et core seal all on ...

[pealuu]

okkei
The hole is for pressure relief. When the IHS is epoxied to the Organic Land Grid Array, or "OLGA" for short, it releases gas as it cures. If Intel did not provide the hole, the pressure would build up and eventually blow out the still wet epoxy. This would cause mechanical stresses due to the incomplete epoxy line around the IHS to OLGA bond line. Once the epoxy has cured (before it leaves the factory) it is not an issue. So, Intel put in a hole. If it gets plugged up with thermal grease or something it is OK. I would not suggest filling it with anything that conducts electricity though."

[lamp]

samas sinna võib sulatina ka lasta, midagi seal pole, mis lyhisesse läheks..
a64 ihs puudus jällegi on just selle augu puudus.. ja lyhisetundlikud komponendid seal all.
niiet kui tahad proset pakasesse lasta, pead ihs eemaldama..

[Henrik]

Hmmm.... Kust sa konfidentsiaalse protsessori said?

[lamp]

tal tomshardwares käpp sees, sealt sai.