praegune kellaaeg 19.06.2025 00:52:11 |
|
Hinnavaatlus
:: Foorum
:: Uudised
:: Ärifoorumid
:: HV F1 ennustusvõistlus
:: Pangalink
:: Telekavad
:: HV toote otsing
|
|
| autor |
|
Chaza!
Kreisi kasutaja
liitunud: 18.07.2006
|
21.01.2014 15:49:28
Reported_Uncorrect - Kas tasub muret tunda? |
|
|
smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.2.0-4-amd64] (local build)
Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net
=== START OF INFORMATION SECTION ===
Device Model: ST2000DL001-9VT156
Serial Number: 6YD129DJ
LU WWN Device Id: 5 000c50 045808236
Firmware Version: CC43
User Capacity: 2,000,398,934,016 bytes [2.00 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: 8
ATA Standard is: ATA-8-ACS revision 4
Local Time is: Tue Jan 21 13:52:46 2014 EET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 612) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 255) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 108 099 006 Pre-fail Always - 439279384
3 Spin_Up_Time 0x0003 095 092 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 232
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 075 060 030 Pre-fail Always - 32405153
9 Power_On_Hours 0x0032 080 080 000 Old_age Always - 18261
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 202
183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 076 076 000 Old_age Always - 24
188 Command_Timeout 0x0032 100 099 000 Old_age Always - 1
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 060 049 045 Old_age Always - 40 (Min/Max 38/40)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 0
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 197
193 Load_Cycle_Count 0x0032 100 100 000 Old_age Always - 237
194 Temperature_Celsius 0x0022 040 051 000 Old_age Always - 40 (0 12 0 0)
195 Hardware_ECC_Recovered 0x001a 026 011 000 Old_age Always - 439279384
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 24
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 24
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 215658897885022
241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 2457738812
242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 1170227380
SMART Error Log Version: 1
ATA Error Count: 24 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 24 occurred at disk power-on lifetime: 18102 hours (754 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 17:35:54.002 READ FPDMA QUEUED
27 00 00 00 00 00 e0 00 17:35:54.002 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 17:35:54.001 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 17:35:54.001 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 17:35:54.001 READ NATIVE MAX ADDRESS EXT
Error 23 occurred at disk power-on lifetime: 18102 hours (754 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 17:35:50.628 READ FPDMA QUEUED
27 00 00 00 00 00 e0 00 17:35:50.628 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 17:35:50.627 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 17:35:50.627 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 17:35:50.627 READ NATIVE MAX ADDRESS EXT
Error 22 occurred at disk power-on lifetime: 18102 hours (754 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 17:35:47.264 READ FPDMA QUEUED
27 00 00 00 00 00 e0 00 17:35:47.264 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 17:35:47.264 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 17:35:47.264 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 17:35:47.263 READ NATIVE MAX ADDRESS EXT
Error 21 occurred at disk power-on lifetime: 18102 hours (754 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 17:35:43.901 READ FPDMA QUEUED
27 00 00 00 00 00 e0 00 17:35:43.901 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 17:35:43.900 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 17:35:43.900 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 17:35:43.900 READ NATIVE MAX ADDRESS EXT
Error 20 occurred at disk power-on lifetime: 18102 hours (754 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 17:35:40.542 READ FPDMA QUEUED
27 00 00 00 00 00 e0 00 17:35:40.542 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 17:35:40.541 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 17:35:40.541 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 17:35:40.541 READ NATIVE MAX ADDRESS EXT
SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay. |
Probleemne? Mul on see Raidi mirroris, nii et data minekut väga karta pole.
_________________
Linux - Future
"Those Who Sacrifice Liberty For Security Deserve Neither." - Benjamin Franklin
1984 was not supposed to be instruction manual |
|
| Kommentaarid: 58 loe/lisa |
Kasutajad arvavad: |
   |
:: |
0 :: |
0 :: |
53 |
|
| tagasi üles |
|
 |
|
| lisa lemmikuks |
|
 |
sa ei või postitada uusi teemasid siia foorumisse
sa ei või vastata selle foorumi teemadele
sa ei või muuta oma postitusi selles foorumis
sa ei või kustutada oma postitusi selles foorumis
sa ei või vastata küsitlustele selles foorumis
sa ei saa lisada manuseid selles foorumis
sa võid manuseid alla laadida selles foorumis
|
|
Hinnavaatlus ei vastuta foorumis tehtud postituste eest.
|
:: KKK
:: otsing 
:: statistika
:: kasutajate nimekiri
:: kasutajate grupid
:: registreeri
teata moderaatorile
