Katkine 2,5-tolline 500GB TOSHIBA MK5055GSX

== START OF INFORMATION SECTION ===
Device Model: TOSHIBA MK5055GSX
Serial Number: XXXXXXXXX
Firmware Version: FG001J
User Capacity: 500 107 862 016 bytes
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: 8
ATA Standard is: Exact ATA specification draft version not indicated
Local Time is: Tue Oct 11 16:11:37 2011 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: FAILED!
Drive failure expected in less than 24 hours. SAVE ALL DATA.
See vendor-specific Attribute list for failed Attributes.

General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 73) The previous self-test completed having
a test element that failed and the test
element that failed is not known.
Total time to complete Offline
data collection: ( 120) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 181) minutes.
SCT capabilities: (0x0039) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.

SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0
2 Throughput_Performance 0x0005 100 100 050 Pre-fail Offline - 0
3 Spin_Up_Time 0x0027 100 100 001 Pre-fail Always - 1640
4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 4208
5 Reallocated_Sector_Ct 0x0033 001 001 050 Pre-fail Always FAILING_NOW 2047
7 Seek_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 100 100 050 Pre-fail Offline - 0
9 Power_On_Hours 0x0032 086 086 000 Old_age Always - 5773
10 Spin_Retry_Count 0x0033 183 100 030 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 1744
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 249
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 115
193 Load_Cycle_Count 0x0032 096 096 000 Old_age Always - 46591
194 Temperature_Celsius 0x0022 100 100 000 Old_age Always - 30 (Min/Max 12/53)
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 354
197 Current_Pending_Sector 0x0032 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0030 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0
220 Disk_Shift 0x0002 100 100 000 Old_age Always - 8252
222 Loaded_Hours 0x0032 090 090 000 Old_age Always - 4089
223 Load_Retry_Count 0x0032 100 100 000 Old_age Always - 0
224 Load_Friction 0x0022 100 100 000 Old_age Always - 0
226 Load-in_Time 0x0026 100 100 000 Old_age Always - 324
240 Head_Flying_Hours 0x0001 100 100 001 Pre-fail Offline - 0

SMART Error Log Version: 1
ATA Error Count: 11737 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.

Error 11737 occurred at disk power-on lifetime: 5773 hours (240 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 07 51 ec 4a e1 Error: UNC 7 sectors at LBA = 0x014aec51 = 21687377

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 50 ec 4a e1 00 1d+01:30:35.687 READ DMA
ef 10 02 00 00 00 a0 00 1d+01:30:35.687 SET FEATURES [Reserved for Serial ATA]
27 00 00 00 00 00 e0 00 1d+01:30:35.687 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 1d+01:30:35.686 IDENTIFY DEVICE
ef 03 42 00 00 00 a0 00 1d+01:30:35.686 SET FEATURES [Set transfer mode]

Error 11736 occurred at disk power-on lifetime: 5773 hours (240 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 07 51 ec 4a e1 Error: UNC 7 sectors at LBA = 0x014aec51 = 21687377

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 50 ec 4a e1 00 1d+01:30:31.754 READ DMA
ef 10 02 00 00 00 a0 00 1d+01:30:31.754 SET FEATURES [Reserved for Serial ATA]
27 00 00 00 00 00 e0 00 1d+01:30:31.754 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 1d+01:30:31.753 IDENTIFY DEVICE
ef 03 42 00 00 00 a0 00 1d+01:30:31.753 SET FEATURES [Set transfer mode]

Error 11735 occurred at disk power-on lifetime: 5773 hours (240 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 07 51 ec 4a e1 Error: UNC 7 sectors at LBA = 0x014aec51 = 21687377

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 50 ec 4a e1 00 1d+01:30:27.821 READ DMA
ef 10 02 00 00 00 a0 00 1d+01:30:27.820 SET FEATURES [Reserved for Serial ATA]
27 00 00 00 00 00 e0 00 1d+01:30:27.820 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 1d+01:30:27.820 IDENTIFY DEVICE
ef 03 42 00 00 00 a0 00 1d+01:30:27.820 SET FEATURES [Set transfer mode]

Error 11734 occurred at disk power-on lifetime: 5773 hours (240 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 07 51 ec 4a e1 Error: UNC 7 sectors at LBA = 0x014aec51 = 21687377

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 50 ec 4a e1 00 1d+01:30:23.887 READ DMA
ef 10 02 00 00 00 a0 00 1d+01:30:23.887 SET FEATURES [Reserved for Serial ATA]
27 00 00 00 00 00 e0 00 1d+01:30:23.887 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 1d+01:30:23.886 IDENTIFY DEVICE
ef 03 42 00 00 00 a0 00 1d+01:30:23.886 SET FEATURES [Set transfer mode]

Error 11733 occurred at disk power-on lifetime: 5773 hours (240 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 07 51 ec 4a e1 Error: UNC 7 sectors at LBA = 0x014aec51 = 21687377

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 50 ec 4a e1 00 1d+01:30:19.954 READ DMA
ef 10 02 00 00 00 a0 00 1d+01:30:19.954 SET FEATURES [Reserved for Serial ATA]
27 00 00 00 00 00 e0 00 1d+01:30:19.954 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 1d+01:30:19.953 IDENTIFY DEVICE
ef 03 42 00 00 00 a0 00 1d+01:30:19.953 SET FEATURES [Set transfer mode]

SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Extended offline Completed: unknown failure 90% 5761 0

SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.